Ricoh G176 Service Manual page 79

Rev. 10/27/2009
822 B Self-diagnostic error 3: HDD
Check performed when HDD is
installed:
HDD device busy for over
31 s.
After a diagnostic command is set for
3003
Sthe HDD, but the device remains
busy for over
6 s.
A diagnostic command is issued to the
HDD device but the result is an erro
No response to the self-diagnostic
3004
command from the ASIC to the HDDs
Self-diagnostic Error: NIC
The network interface board
823 B
returned an error during the
self-diagnostic test.
Self-diagnostic error 4: NVRAM
NVRAM device does not exist,
824 D
NVRAM device is damaged,
NVRAM socket damaged
Self-diagnostic Error:
NVRAM/Optional NVRAM
826 D
The NVRAM or optional NVRAM
returned an error during the
self-diagnostic test.
SM
Service Call Conditions
HDD defective
HDD harness
disconnected,
defective
Controller board
defective
HDD defective
Network interface board defective
Controller board defective
NVRAM defective
Controller board defective
NVRAM backup battery exhausted
NVRAM socket damaged
Make sure NVRAM is seated
correctly in its socket
Replace the NVRAM on the
controller board
4-9 G176/G177/G176L