Ricoh G176 Service Manual page 89

1st/2nd Message
Close Duplex Unit Cover
Close Front Cover
Close Rear/Paper Exit Cover
DHCP assigned, Cannot change
Error: Enter 10, or 26 Characters
Error: Enter 5, or 13 Characters
Hardware Problem, Ethernet
Hardware Problem, HDD
Hardware Problem, Option RAM
Hardware Problem, Parallel I/F
SM
Problem/Solution
The duplex unit cover is open.
Close the duplex unit cover.
The front cover is open.
Close the front cover.
The paper output tray cover or the rear cover is open,
or both covers are open.
Check the covers, make sure they are closed.
DHCP has been enabled to assign network
addresses of: IP address, subnet mask, gateway
address.
Disable DHCP in host interface network setup to
change any of these addresses.
Number of hex characters entered for the WEP key is
incorrect.
Enter correct number of characters.
Number of ASCII characters entered for the WEP key
is incorrect.
Enter correct number of characters.
Machine detected an Ethernet error.
Replace controller board.
Machine identified a HDD Board error.
Replace HDD board.
Machine detected an optional RAM error.
Replace optional RAM.
Machine failed self-diagnostic test due to a loop back
error.
If parallel I/F is in use, replace the IEEE1284
interface board.
4-19
Error Messages
G176/G177/G176L