Ricoh G176 Service Manual page 90

Error Messages
1st/2nd Message
Hardware Problem, Printer Font
Hardware Problem, USB
Hardware Problem, Wireless
Board
Hardware Problem, Wireless
Card
Invalid Data, Power Off On
Invalid Password, Try again
Load Correct Size Paper/ Paper
Size:, Paper Type:
Load Paper: Tray# or Form Feed
G176/G177/G176L
Problem/Solution
Problem with machine font file.
Replace print module.
Machine detected a USB I/F board error.
Replace the USB I/F board.
Access to the IEEE 802.11b board was possible, but
an error has been detected.
Machine can access IEEE802.11b board but an error
was detected.
Confirm that the board is installed correctly.
Machine failed to access IEEE 802.11b board.
Confirm that the board is installed correctly.
Machine has received spurious data.
Turn the printer off/on.
The invalid password was entered and Locked Print
or Saved File Print is not applicable.
Invalid password entered, Locked Print or Saved File
Print cannot apply.
Printer displays this message for 4 sec., then returns
to previous display.
Enter correct password.
Size of paper selected does not match size selected
with dial on paper tray.
Use the dial to select the correct paper size.
-or-
Press [Form Feed].
The specified tray is out of paper.
Load paper in the specified tray.
4-20 SM