Ricoh G176 Service Manual page 57

[A] Fusing Lamp ( x2)
The colored cable must be at the hot roller gear side.
[B] Guide plate (3 hooks)
[C] Hot roller strippers (1 spring each)
[D] Hot roller (2 C-rings, 1 gear, 2 bushings)
Before removing the hot roller from the unit, remove the gear and the pin first,
Use a small screwdriver to separate the guide plate from the unit.
Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the
protective sheet on the new hot roller. Be sure to remove the remaining paper
before starting the machine.
SM 3-17
Fusing
G176/G177/G176L