Mute Specified Output; Unmute Specified Output; Lock The Output; Unlock The Output - Lightware HDMI-TPS-TX210 User Manual

7.3.2. Mute specified output

Description: Mute output <out>. The output signal is turned off.
Command {#<out>●<layer>}
Response (1MT<out²>●<layer>)CrLf
Explanation: The O1 audio port is muted.
Legend: See section
Info: Muting does not change the crosspoint state, but disables the output itself. This way the
last connection can be easily restored with an unmute command.
Info: Switching a muted output does not unmute the output.

7.3.3. Unmute specified output

Description: Unmute output <out>.
Command {+<out>●<layer>}
Response (0MT<out²>●<layer>)CrLf
Explanation: The O1 audio port is unmuted.
Legend: See section
Info: Unmuting an output makes the previous connection active as the crosspoint state has not
been changed by the muting command, only the output was disabled.

7.3.4. Lock the output

Description: Lock an output port. Output's state cannot be changed until unlocking.
Command {#><out>●<layer>}
Response (1LO<out²>●<layer>)CrLf
Explanation: O1 audio output port is locked.
Legend: See section

7.3.5. Unlock the output

Description: Unlock an output port. The connection on output can be changed.
Command {+<<out>●<layer>}
Response (0LO<out²>●<layer>)CrLf
Explanation: O1 audio output port is unlocked.
Legend: See section
Info: The device issues the above response regardless of the previous state of the output (either
it was locked or unlocked).
Page 64 / 122
Format
7.3.1 on page 63.
Format
7.3.1 on page 63.
Format
7.3.1 on page 63.
Format
7.3.1 on page 63.
Example
→ {#01 A}
← (1MT01 A)CrLf
Example
→ {+01 A}
← (0MT01 A)CrLf
Example
→ {#>01 A}
← (1LO01 A)CrLf
Example
→ {+<01 A}
← (0LO01 A)CrLf
Section 7. LW2 Programmer's reference