Change Video Autoselect Mode; Query Audio Autoselect Mode; Change Audio Autoselect Mode - Lightware HDMI-TPS-TX210 User Manual

7.3.9. Change video Autoselect mode

Description: The autoselect mode of the video outputs can be changed.
Command {AS_V<out>=<state>;
Response (AS_V<out>=<state>;
Legend: See section
Explanation: The Autoselect mode is enabled in first detect mode, and if there is no
incoming signal at all, the crosspoint is not changed (blank screen is shown).
Info: In this case the outputs are linked; the change will affect both local and TPS output port.

7.3.10. Query audio Autoselect mode

Description: The autoselect mode of audio outputs can be queried.
Command {AS_A<out>}
Response (AS_A<out>=<state>;
Legend:
Explanation: The Autoselect mode is enabled in first detect mode, and if there is no
incoming signal at all, the crosspoint is not changed.
Info: In this case the outputs are linked; the change will affect both local and TPS output port.

7.3.11. Change audio Autoselect mode

Description: The autoselect mode of audio output ports can be changed.
Command {AS_A<out>=<state>;
Response (AS_A<out>=<state>;
Legend: See section
Explanation: The Autoselect mode is enabled in first detect mode, and if there is no
incoming signal at all, the crosspoint is not changed.
Info: In this case the outputs are linked; the change will affect both local and TPS output port.
Page 66 / 122
Format
<mode>;<no_signal>}
<mode>;<no_signal>)CrLf
7.3.8 on page 65.
Format
<mode>;<no_signal>)CrLf
<out>: The output port number. See more details about port
numbering in section
<state>: E = Autoselect is enabled; D = Autoselect is disabled
<mode>: P = Priority detect; K = First detect; L = Last detect; S = Static
<no_signal>: B = Blank; M = Mute output
Format
<mode>;<no_signal>}
<mode>;<no_signal>)CrLf
7.3.8 on page 65.
Example
→ {as_v1=E;K;B}
← (AS_V1=E;K;B)CrLf
Example
→ {as_a1}
← (AS_A1=E;K;B)CrLf
11.4 on page 118.
Example
→ {as_a1=E;K;B}
← (AS_A1=E;K;B)CrLf
Section 7. LW2 Programmer's reference