Edid Menu; Sources And Destinations - Lightware HDMI-TPS-TX210 User Manual

6.7. EDID menu

Advanced EDID Management can be accessed by selecting the EDID menu. There are
two panels: left one contains Source EDIDs, right one contains Destination places where
the EDIDs can be emulated or copied.
Control buttons

6.7.1. Sources and Destinations

The EDID memory consists of four parts:
Factory EDID list shows the pre-programmed EDIDs (F1-F119).
Dynamic EDID List shows the display device connected to the device's outputs. The unit
stores the last display devices' EDID on either output, so there is an EDID shown even if
there is no display device attached to the output of the transmitter at the moment.
User memory shows the memory locations (U1 – U14) which can be used by the user to
save custom EDIDs.
Emulated EDID list shows the currently emulated EDID for the inputs. The source column
displays the memory location that the current EDID was routed from.
Page 46 / 122
Exporting an EDID
Save
(save to a file)
Importing an EDID
Load
(load from a file)
Display EDID
Info
Summary window
Opening Advanced
Edit EDID Editor with the
selected EDID
Opening Easy EDID
EEC
Creator
Section 6. Software control – using Lightware Device Controller (LDC)
Figure 6-4. EDID menu
Clear selected
Select All
Unselect All
Executing EDID
emulation or copying
(Transfer button)
Deleting EDID
(from user memory)
Selecting all memory
places in the right panel
Selecting none of the
memory places in the
right panel