Front View Legend - Lightware HDMI-TPS-TX210 User Manual

2.2. Front view legend

HDCP LED
1
HDMI in
2
Reset
3
4 Show me
5 Autoselect LED
Audio in
6
7 Audio select
DVI-D in
8
DP in
9
10 Video select
Audio and Video LEDs
The input ports have their own LEDs regarding the Audio and/or Video state. The functions
of these LEDs are the same and refer to the given input port.
Audio LEDs
Video LEDs:
Info: When Autoselect is enabled and video signal is not present at all, video LEDs blink.
Info: A port is active if there is a valid signal on it.
Section 2. Controls and connections
dark: video output signal is not encrypted with HDCP
lights: video output signal is encrypted with HDCP
Connect a HDMI cable between the source and the transmitter. Applied
cable shall not be more, than 30 m (when signal is 1080p) and 15 m (when
signal is 4K). Pin assignment can be found in section
Reset button reboots the extender. This is the same as disconnecting the
device from the power source and reconnecting it again.
Special functions are available with this button (switch to bootload mode,
enable DHCP, restore factory default settings). For details about the
special functions see the section
dark: autoselect function is OFF
blinks: searching for signal (the video LEDs also blink)
lights: active video signal was found (the selected video LED also lights)
3.5 mm Jack connector for asymmetric analog audio input signal. Pin
assignment can be found in section
Switching between audio inputs is available with this button.
29-pole DVI-I connector for DVI-D signal. Applied cable shall not be more,
than 30 m (when signal is 1080p) and 15 m (when signal is 4K). Pin
assignment can be found in section
DisplayPort input connector. Applied cable shall not be more, than 30 m
(at 2.7 Gbps data speed). Pin assignment can be found in section
page 20.
Switching among video inputs is available with this button.
dark: the audio source is not selected
blinks: the audio source is selected but not active, regardless of the output mode
(e.g. DVI EDID is emulated on the port with HDMI signal)
lights: (with short pause): audio source is selected, the port is active but audio is
not embedded to the video stream (e.g. the output mode is DVI).
(continuously): audio source is selected, active and the audio is embedded
to the output video stream.
dark: video source is not selected
blinks: video source is selected but not active
lights: video source is selected and the port is active
HDMI-TPS-TX200 series
2.5.2
5.2 on page 32.
2.5.8 on page 22.
2.5.1 on page 19.
User's Manual
on page 19.
2.5.3 on
Page 15 / 122