Advanced Mode - Lightware HDMI-TPS-TX210 User Manual

Actions of the Event Manager Wizard
Below table lists the Actions, which are grouped by layers in LDC:
Layer
Video
Audio
GPIO
RS-232 Send RS232 message
* Referring to SW4-TPS-TX-240. The port numbers are only for references. Exact port numbers
can be found in section

6.9.3. Advanced mode

The goal of this mode is the same as of the wizard: set the properties and methods for
conditions and actions. The difference is the number of the available and usable properties
and methods. The LW3 protocol tree allows almost all the methods and settings to select.
Step 1. Click on the Advanced button; a new window pops up.
Step 2. Select the desired node: click on the folder sign.
Page 56 / 122
Action
Switch output to input
Switch output to next
input
Enable autoselect on
output
Disable autoselect on
output
Switch output to input:
Switch output to next
input
Enable autoselect on
output
Disable autoselect on
output
Set output state to "High" /MEDIA/GPIO/P1.Output=H
Set output state to "Low" /MEDIA/GPIO/P1.Output=L
Toggle output state
11.4 on page 118.
Table 6-2. Actions of the Event Manager Wizard
Section 6. Software control – using Lightware Device Controller (LDC)
Path and value in LW3 protocol tree*
/MEDIA/VIDEO/XP1:switch(P1:P5)
/SYS/MB:SwitchToNextSource(V)
/MEDIA/VIDEO/XP1:setDestinationPortAutoselect(P5:E)
/MEDIA/VIDEO/XP1:setDestinationPortAutoselect(P5:D)
/MEDIA/AUDIO/XP1:switch(P1:P6)
/SYS/MB:SwitchToNextSource(A)
/MEDIA/AUDIO/XP1:setDestinationPortAutoselect(P6:E)
/MEDIA/AUDIO/XP1:setDestinationPortAutoselect(P6:D)
/MEDIA/GPIO/P1:toggle()
/MEDIA/UART/P1:sendMessage(...)