Tps Output Port Properties And Mode Settings - Lightware HDMI-TPS-TX210 User Manual

6.6.3. TPS output port properties and mode settings

Muting/Locking
TPS output can be muted by clicking on the button Unmuted. If the output is muted, button
text is Muted. When the port is muted, no signal is present on the output.
TPS output can be locked by clicking on the button Unlocked. If the output is locked, button
text is Locked. If the port is locked, its mute state cannot be changed either by the button,
or by loading a preset.
No sync screen
When there is no incoming signal on the selected input port, a
static image can be sent on the output port(s).
Mode:
Clock source: Set the desired resolution: 480p / 576p /
Pattern:
Autoselect
The autoselect feature can be set via the TPS
OUT properties panel as follows:
Settings
Input priorities
The available input ports are listed; each one
has its own priority number (equal numbers are
allowed). If you want to disable a port from the
priority list, uncheck the setting next to the
priority number and the priority number will be
emptied and disabled. Smaller number means
higher priority as usual. Priority 31 is the lowest
priority, in this case the port will not be checked
and cannot be selected.
Always press the Set priorities button after the
modification to store the settings.
Section 6. Software control – using Lightware Device Controller (LDC)
No sync – No sync-screen signal is sent when
there is no incoming signal.
On – No sync-screen signal is sent always,
independently from the incoming signal.
Off – No sync-screen is disabled.
External clock source (from actual TMDS
source).
Select the desired color or the pre-defined
pattern from the list.

Enabled: The Autoselect mode is ON.

Disabled: The Autoselect mode is OFF.

Priority detects: Priority detect mode is
active (see section

First detect: First detect mode is active
(see section 5.1.3 on page 29).

Last detected: Last detect mode is
active (see section

Static: Static mode is active (see
section 5.1.5 on page 30). Available
only at TPS Audio out.
5.1.6 on page 31).
5.1.4 on page 30).
HDMI-TPS-TX200 series
User's Manual
Page 43 / 122