Change Audio Input Priority; Batch Switch Outputs - Lightware HDMI-TPS-TX210 User Manual

7.3.15. Change audio input priority

Description: The settings of audio input priority can be changed as follows.
Command {PRIO_A<out>=<in1_prio>;
Response (PRIO_A<out>=<in1_prio>;
Legend:
Explanation: I2 has the highest priority (0), P1 has the second highest (2). P5 has the
lowest priority (5).
Info: Always set all the ports' priority when changing, otherwise the change will not be executed
and the response will be the current setting (like querying the priority setting).
Info: In this case the outputs are linked; the change will affect both local and TPS output port.

7.3.16. Batch switch outputs

Description: The device is capable of switching multiple outputs exactly at the same time.
To do this, the normal switch commands have to be used. If the switch commands arrive
to the device with less than 10 milliseconds delay, the commands are collected and
changes the output connections together. Required circumstances:
If any of the above circumstances fail, then the commands will be processed separately.
Info: The delay timeout applies for the receiving time of characters. Please note that if LAN
connection is used then the network may cause additional delays. This could result that
batch switching does not occur.
The below example shows a command that resulted batch switching:
→ {2@1 V}CrLf
← (O01 I02 V)CrLf
← (O01 I02 A)CrLf
← (O02 I02 V)CrLf
← (O02 I02 A)CrLf
→ {5@1 A}CrLf
← (O01 I05 A)CrLf
← (O02 I05 A)CrLf
Page 68 / 122
Format
<in2_prio>;...;<in
<in2_prio>;...;<in
<out>:
<in1_prio>...<in

Switch commands have this format: {<in>@<out>}{<in>@<out>}
 The delay between two '}' characters must be below 10 milliseconds

No other command or junk character is allowed between switch commands

Affected outputs must be unlocked
One by one commands
→ {prio_a1=1;0;2;3;4}
_prio>}
n
← (PRIO_A1=1;0;2;3;4)CrLf
_prio>)CrLf
n
The output port number.
_prio>: Input ports' priority number. See more details about
n
port numbering in section
→ {02@01 V}{05@01 A}CrLf
← (O01 I02 V)CrLf
← (O01 I02 A)CrLf
← (O02 I02 V)CrLf
← (O02 I02 A)CrLf
← (O01 I05 A)CrLf
← (O02 I05 A)CrLf
Section 7. LW2 Programmer's reference
Example
11.4 on page 118.
Batch commands