Settings Menu; Status Tab; Network Tab - Lightware HDMI-TPS-TX210 User Manual

6.10. Settings menu

Device status information and network settings are available in this menu, function buttons
help to do operations in connection with logs and device settings.

6.10.1. Status tab

General information is shown on this tab, such as device label, part number, serial number
and hardware health, voltage and temperature values.

6.10.2. Network tab

Network-related settings are available on the tab. The first three (two) lines are valid when
the device has a fix IP address. If dynamic IP address is used, the DHCP setting shall be
set to enabled and the IP parameters will be indicated below the drop-down menu.
Since the device is able to communicate with LW2 and LW3 protocols, the ports can also
be set here. Always press the Apply changes button after modification to store the settings;
you will be prompted to reboot the device to apply changes in practice.
Page 58 / 122
Figure 6-11. Status tab
Figure 6-12. Network tab
Section 6. Software control – using Lightware Device Controller (LDC)