The Event Area - Lightware HDMI-TPS-TX210 User Manual

6.9.1. The event area

1
1 Number of the event
2 Condition
Name of the event
3
4 Action
5 Set name button
6 Set condition (wizard)
Set condition (advanced) Advanced setting contains a wide range of LW3 expressions,
7
Set action (wizard)
8
9 Set action (advanced)
Clear event button
10
11 Check bar
Page 52 / 122
2 3
6 7
Figure 6-10. First event (E1) settings
20 events can be defined in the transmitter, the label shows
the number of them (E1-E20).
If the condition was set, the description (white colored text)
and the exact LW3 protocol expression (yellow colored text)
can be seen. If advanced mode was used the description is
"Custom condition".
Text as the name of the event can be stored. Click into the
text box and type desired name.
If the action was set, the description (white colored text) and
the exact LW3 protocol expression (yellow colored text) can
be seen. If advanced mode was used the description is
"Custom action".
The device stores the name of the event if the Set name
button was pressed. The button is dark when the name is
already saved.
Run the wizard to choose from the most common expressions
as a condition.
which are displayed in a tree structure.
Run the wizard to choose from the most common expressions
as an action.
Advanced setting contains a wide range of LW3 expressions,
which are displayed in a tree structure.
Unwanted events can be cleared with a single click on this
button. Confirmation is needed for deleting.
If the event is ready and syntactically correct the check bar
becomes green.
Section 6. Software control – using Lightware Device Controller (LDC)
4 5
8 9
10
11