Control Menu; Tab - Lightware HDMI-TPS-TX210 User Manual

6.8. Control menu

The menu gives the opportunity to setup those channels which can be used to connect or
control third party devices.
6.8.1. RS-232 tab
General Settings
There are three RS-232 working modes: Pass-
through-, Control- and Command Injection modes.
See more details in section
Port settings
Two lines are available:
The settings are the same but different parameters
can be set for Local and Link ports.
Command injection
If the RS-232 mode is set to Command injection,
this section is activated and the port number can be
set. Default values: 8001 (local) and 8002 (link).
Control protocol
The active protocol can be set by the drop-down
menu: LW2 or LW3 protocol.
Other
The terminal line can be used to send commands to the destination in pass-through mode.
Page 50 / 122
Figure 6-8. Control menu (RS-232 tab)

Local: RS-232 connection between the
CPU and the 3-pole Phoenix connector

Link: RS-232 connection between the CPU
and the receiver unit (via TPS line)
Section 6. Software control – using Lightware Device Controller (LDC)
5.5 on page 34.