Features - Lightware HDMI-TPS-TX210 User Manual

1.6. Features

Certain features depend on the configuration of the model. For more information about the
models see section
Page 12 / 122
1.3 on page 11.
 3D and 4K support – High bandwidth allows extension of resolutions up to 4K and
even 3D sources and displays are supported.
Signal transmission up to 170 m – Video and audio signal transmission (DVI,

HDMI or DisplayPort, and Ethernet + RS-232 + Infra-Red over a single
CAT5e...CAT7e cable.
Various audio and video connectors – DVI-I, HDMI, DisplayPort, Stereo jack.

 GPIO control port – 7 GPIO pins operating at TTL digital signal levels and can be
controlled with both LW2 and LW3 commands.
 HDCP compliant – HDMI-TPS-T200 series fulfils HDCP standard. HDCP
capability on the digital video inputs can be disabled when non-protected content
is extended.
 Advanced EDID management – User can emulate any EDID on the input ports,
read out and store any monitor's EDID in the internal memory.
Pixel Accurate Reclocking – (removes jitter caused by long cables) The output

has a clean, jitter free signal, eliminating signal instability and distortion caused by
long cables or connector reflections.
 Frame detector and signal analysis – Using Lightware Device Controller
software the exact video and audio signal format can be determined such as timing,
frequencies, scan mode, HDCP encryption, color range, color space and audio
sample rate.
 Deep Color support and conversion – It is possible to transmit the highest quality
36-bit video streams for perfect color reproduction.
 DVI/HDMI, DP/DVI, DP/HDMI conversion – The transmitter is able to convert the
input video signal to another format so that you can watch the video on your local
display in another format.
 Bi-directional RS-232 pass-through – AV systems can also contain serial port
controllers and controlled devices. Serial port pass-through supports any unit that
works with standard RS-232.
Remote power – The transmitters are PoE-compatible and can be powered locally

by the supplied power adaptor, or remotely via the TPS connection (through the
CATx cable) with a compatible Power Source Equipment.
 Locking DC connector – Special plug of wall adaptor ensures safe power supply.
This type of connector prevents unwanted extractions.
 Separate Audio and Video switching – Video and audio signals are separated
and can be switched independently.
 Analog Audio conversion – Analog audio signal is converted to digital before
being sent to the output.
 Input (video & audio) status LEDs – Front panel LEDs give feedback about state
of the unit and the video and audio signals.

Accepts analog and digital audio signals - Accepts analog stereo; 5.1 S/PDIF
and even 7.1 HDMI embedded audio signals. Analog signals are converted to
digital format and the digital or digitized analog audio can be embedded in the
video stream.
 Auto-switch function for video and audio inputs – Autoselect mode with or
without priority can toggle between inputs. It helps the handling of the transmitter
and installation of new devices (SW4-TPS-TX240).
Section 1. Introduction