Rear View Legend - Lightware HDMI-TPS-TX210 User Manual

2.4. Rear view legend

HDMI out
1
TPS out
2
Ethernet
3
4 Status LEDs
IR in
5
IR out
6
RS-232
7
DC in
8
GPIO
9
10 DVI-D out
Status LEDs
LIVE LED
RS-232 LED
SRVC LED
LINK LED
Info: See more information about TPS link modes in section
Page 18 / 122
Local HDMI output with the same A/V content as the TPS output.
Pin assignment can be found in section
Locking RJ45 connector. Connect a twisted pair cable between
the transmitter and the receiver. Remote powering also happens
through this connector. Pin assignment can be found in section
2.5.4
found in section
Locking RJ45 connector. Remote control port for connecting the
extender to a Local Area Network (LAN). Pin assignment can be
found in section
The LEDs give immediate feedback about device's state, RS-232
and TPS link state. For more information see the table below.
3-pole TRS connector, also known as 3.5 mm (1/8") jack plug for
optional IR receiver only. Pin assignment can be found in section
2.5.10
3-pole TS connector, also known as 3.5 mm (1/8") jack plug for
optional IR transmitter only. Pin assignment can be found in
section
3-pole Phoenix connector for RS-232 serial port. Pin assignment
can be found in section
Local power in; connect the output of the supplied +12V DC
power adaptor or use Lightware's rack mountable power supply
unit (PSUx10-200-12V or PSUx20-400-12V).
8-pole Phoenix connector for configurable general purpose
input/output ports. Pin assignment can be found in section
on page 22.
29-pole DVI-I connector for DVI-D signal with embedded audio;
local output with the same A/V content as the TPS output. Pin
assignment can be found in section
dark: device is not powered
blinks: (slow): device is powered and operational
(fast): device is in bootload mode
lights: device is powered but no operation
dark: RS-232 ports (Local and Link) are in Pass-through mode
blinks: command injection mode is active
lights: RS-232 ports (Local and Link) are in Control mode
Reserved for future developments.
dark: no TPS link between transmitter and receiver
blinks: (slow): low power mode is active
(fast): Ethernet fallback mode is active
lights: TPS link is established, HDBaseT or Long Reach mode is active
on page 20. Maximum twisted pair cable distances can be
11.3 on page 118.
2.5.5 on page 21.
on page 22.
2.5.10 on page 22.
2.5.6
Section 2. Controls and connections
2.5.2 on page 19.
on page 21.
2.5.1 on page 19.
0 on page 43.
2.5.8