Backup Tab - Lightware HDMI-TPS-TX210 User Manual

6.10.3. Backup tab

The transmitter's settings can be saved and loaded to/from the computer. When creating a
backup, the following settings are stored:
Create a full backup
Step 1. Arrange the desired settings in the transmitter.
Step 2. Navigate to Settings/Backup menu.
Step 3. Write a short description in the textbox on the left (optionally).
Step 4. Press the Create a full backup button. You will be prompted to save the file to the
Restore a backup file
Previously saved backup file can be restored as follows:
Step 1. Navigate to the Settings/Backup menu.
Step 2. Click on the Choose file button on the right panel and browse the desired file.
Step 3. The file is checked and the result will be displayed in the textbox below. If the file is
Step 4. Press the Start restore process button. The process is displayed in a small window;
Important: Please note that the settings will be overwritten with the restored parameters in the
transmitter permanently. Withdrawal is not possible.
Section 6. Software control – using Lightware Device Controller (LDC)
 All ports' AND crosspoint settings (writeable properties' values) of all layers,

All EDID data stored in the User memory,

All Control settings set on the Control tab,

All Events (from the Event manager) and

Network settings.
computer (select the desired folder and save the file).
correct, the settings can be restored.
when finished, you can continue the work with the LDC.
Figure 6-13. Backup tab
HDMI-TPS-TX200 series
User's Manual
Page 59 / 122