View Connection State On The Output; View Crosspoint Size; Query Video Autoselect Mode - Lightware HDMI-TPS-TX210 User Manual

7.3.6. View connection state on the output

Description: Viewing the crosspoint state of the device; showing the input port numbers
connected to the outputs. The response below refers to an SW4-TPS-TX240.
Command {VC●<layer>}
Response (ALL<layer>●<O01>●<O02>)
Legend: O01 and O02 show the corresponding output's connection state. If value<O01>
equals 02 it means that output 1 is connected to input 2.
* AV is not used in the response. When AV is typed in the commands, the response will
result two lines, one for the Video and one for the Audio port states.
Explanation: I2 video input port is connected to the video output ports and I5 audio input
port is connected to the audio output ports.
Info: If an output is locked, muted, or both locked and muted, the response format changes. If
outputs are muted you get a letter 'M', if locked a letter 'L' and if muted and locked at the
same time 'U' before the 2 digit numbers.

7.3.7. View crosspoint size

Description: Shows the physical crosspoint size.
Command {getsize●<layer>}
Response (SIZE=<size>●<layer>)CrLf
Legend:
Explanation: The device reports that it has a video crosspoint with 5 inputs and 2 outputs,
and an audio crosspoint with 5 inputs and 2 outputs.

7.3.8. Query video Autoselect mode

Description: The autoselect mode of video outputs can be queried.
Command {AS_V<out>}
Response (AS_V<out>=<state>;
Legend:
Explanation: The Autoselect mode is enabled in first detect mode, and if there is no
incoming signal at all, the crosspoint is not changed (blank screen is shown).
For more information about the autoselect modes see the section
Info: In this case the outputs are linked; the change will affect both local and TPS output port.
Section 7. LW2 Programmer's reference
Format
CrLf
<layer>
Format
<size>: <number of inputs>x<number of outputs>
<layer>: See section
Format
<mode>;<no_signal>)CrLf
<out>: The output port number. See more details about port
numbering in section
<state>: E = Autoselect is enabled; D = Autoselect is disabled
<mode>: P = Priority detect; K = First detect; L = Last detect
<no_signal>: B = Blank screen; M = Mute output
Example
→ {vc av}
←
(ALLV 02 02)CrLf
←
(ALLA 05 05)CrLf
Layer
A Audio layer
V Video layer
AV* Audio & Video layer
Example
→ {getsize av}
←
(SIZE=5x2 V)CrLf
←
(SIZE=5x2 A)CrLf
7.3.6 on page 65.
Example
→ {as_v1}
← (AS_V1=E;K;B)CrLf
11.4 on page 118.
HDMI-TPS-TX200 series
User's Manual
5.1 on page 28.
Page 65 / 122