Verifying Bridge Settings - Zhone etherxtend 3300 series User Manual

Verifying bridge settings

Adding a bridge
Enter bridge add interface/type to create a bridge with a VLAN ID of 50.
zSH> bridge add 1-1-2-0/eth vlan 50
Adding bridge on 1-1-2-0/eth
To verify bridge settings, enter get bridge-interface-record for each bridge.
This command displays the bridge settings, including the learnMulticast and
forwardToMulticast.
For the uplink bridge, note that the forwardToMulticast setting is true and the
learnMulticast setting is false.
zSH> get bridge-interface-record 1-1-201-0-efmbond/bridge
vpi: ---------------------->
vci: ---------------------->
vlanId: ------------------->
stripAndInsert: ----------->
customARP: ---------------->
filterBroadcast: ---------->
learnIp: ------------------>
learnUnicast: ------------->
maxUnicast: --------------->
learnMulticast: ----------->
forwardToUnicast: --------->
forwardToMulticast: ------->
forwardToDefault: --------->
bridgeIfCustomDHCP: ------->
bridgeIfConfigGroupIndex: ->
vlanIdCOS: ---------------->
outgoingCOSOption: -------->
outgoingCOSValue: --------->
s-tagTPID: ---------------->
s-tagId: ------------------>
s-tagStripAndInsert: ------>
s-tagOutgoingCOSOption: --->
s-tagIdCOS: --------------->
s-tagOutgoingCOSValue: ---->
For the downlink bridge, note that the forwardToMulticast setting is false and
the learnMulticast setting is true.
zSH> get bridge-interface-record 1-1-3-0-eth/bridge
bridge-interface-record
vpi: --------------------------------->
vci: --------------------------------->
vlanId: ------------------------------>
stripAndInsert: ---------------------->
customARP: --------------------------->
filterBroadcast: --------------------->
{0}
{0}
{0}
{false}
{true}
{true}
{false}
{false}
{0}
{false}
{true}
{true}
{false}
{true}
{0}
{0}
{disable}
{0}
{0x8100}
{0}
{false}
{s-tagdisable}
{0}
{0}
1-1-3-0-eth/bridge
{0}
{0}
{800}
{true}
{false}
{false}
EtherXtend User's Guide
Verifying bridge settings
105