Table of Contents
Advertisement
Configuring Bridging
zSH> bridge add 1-1-40-0/efmbond uplink
Adding bridge on 1-1-40-0/efmbond
Created bridge-interface-record 1-1-40-0-efmbond-0/bridge
zSH> bridge show
Typ VLAN
---------------------------------------------------------------------------------
dwn
M: 150 sec, I: 0 sec]
upl Tagged
M: 150 sec, I: 0 sec]
dwn
EtherXtend CO mode with subtended EtherXtends in CPE mode
110
EtherXtend User's Guide
To create a bridge path for the uplink enter, bridge-path add interface/
type global:
zSH>
bridge-path add 1-1-40-0-efmbond-0/bridge global
Bridge-path added successfully
3
To create a downlink bridge on the LAN interface, enter bridge add
interface/type downlink VLAN 100:
zSH> bridge add 1-1-1-0/eth downlink vlan 100
Adding bridge on 1-1-1-0/eth
Created bridge-interface-record 1-1-1-0-eth/bridge
4
To verify the bridges created, enter bridge show:
Bridge
123 1-1-4-0-eth/bridge
1-1-40-0-efmbond-0/bridge
100 1-1-1-0-eth/bridge
EtherXtend configurations can bridge together devices in both CO mode and
CPE mode.
Configure the EtherXtend in CO mode
The EtherXtend can be configured in CO mode which uses an uplink bridge
to the outside network and a downlink bridges to subtended EtherXtends in
CPE mode.
Figure 18
shows one EtherXtend device in CO mode and two EtherXtend
devices configured in CPE mode. The EtherXtend CPE 1 uses a TLS bridge
with VLAN 100 to connect the WAN to the LAN. The EtherXtend CPE 2 also
uses a TLS bridge with VLAN 200 to connect the WAN to the LAN.
St
Table Data
UP
D 00:13:72:de:92:2e
D 00:1a:6d:13:19:8f
S VLAN 123 default [U: 3600 sec,
UP S Global default [U: 3600 sec,
DWN
Advertisement
Table of Contents
