Table of Contents
Advertisement
Basic Configuration
zSH> swversion
Zhone ethXShdsl software version ETHX 1.14.2.119
zSH> bridge show
Type VLAN
-------------------------------------------------------------------------------------
tls
tls Tagged
tls
tls Tagged
tls
tls Tagged
50
EtherXtend User's Guide
•
Adds a DHCP client interface using VLAN 7 on the bond group for
device management over the WAN.
•
Creates a TLS bridge for tagged VLAN traffic (VLAN 0) and a TLS
bridge for untagged traffic on each of the four LAN Ethernet interfaces
and the SHDSL efmbond group.
MALC as a DHCP server
Auto-provisioning automatically runs when an EtherXtend is upgraded to a
version of software that runs auto-provisioning from a version of the software
that did not run auto-provisioning. When auto-provisioning runs after an
upgrade, some of the existing configuration will be overwritten, specifically
bridges and the IP interfaces.
Auto-configuration runs just once during the initial boot of the EtherXtend
and runs once after a set2default. When upgrading the EtherXtend software
from a verison of the software that supports auto-provisioning,
auto-provisioning does not run again except after using the set2default
command.
For a description of how to create user-defined defaults and bypass
EtherXtend auto-provisioning to factory defaults, see
EtherXtend default settings on page
To verify the version of the software running on an EtherXtend enter
swversion:
To view the auto-provisioned configuration, enter bridge show:
Bridge
7 1-1-99-0-efmbond/bridge
1-1-99-0-efmbond-0/bridge
7 1-1-1-0-eth/bridge
1-1-1-0-eth-0/bridge
7 1-1-4-0-eth/bridge
1-1-4-0-eth-0/bridge
1-1-99-0/efmbond bond group
EtherXtend as a DHCP client with IP address
53.
St
Table Data
UP
UP
DWN
DWN
DWN
DWN
WAN/LAN TLS
bridge interfaces
Customize the
Advertisement
Table of Contents
