Table of Contents
Advertisement
Configuring Bridging
zSH> bond show all
Slot
GrpId
1
40
zSH> bridge add 1-1-40-0-efmbond-0/bridge tls
zSH> bridge add 1-1-1-0-eth/bridge tls
fm1> bridge show
Typ VLAN
---------------------------------------------------------------------------------
tls
tls
112
EtherXtend User's Guide
zSH>
bridge-path add 1-1-40-0-efmbond-0/bridge global
Bridge-path added successfully
3
To create the downlink bridge on the WAN port for CPE 1 using VLAN
100, enter bridge add interface/type downlink vlan 100:
zSH> bridge add 1-1-40-0/efmbond downlink vlan 100
All bridge traffic will be forwarded to the EtherXtend CPE 1 on VLAN
100.
4
To create the downlink bridge for CPE 2 with VLAN 200 on the WAN
port, enter bridge add interface/type downlink vlan 200:
zSH> bridge add 1-1-40-0/efmbond downlink vlan 200
All bridge traffic will be forwarded to the EtherXtend CPE 2 on VLAN
200.
Configure the EtherXtend in CPE mode
The subtended EtherXtends in CPE mode are configured with TLS bridges to
direct traffic to the subscriber.
Creating TLS bridges on the EtherXtend CPE 1
When using TLS bridges on a device, both the WAN port and the LAN port
must use TLS bridges.
1
To find the bond group number on the WAN, enter the bond show all:
Bond Groups
Name
1-1-40-0
2
To create a TLS bridge interface on the WAN port using the bond group
number, enter bridge add interface/type tls:
3
To create a TLS bridge interface on the LAN port to the business, enter
bridge add interface/type tls:
4
To verify the bridges created, enter bridge show:
Bridge
0 1-1-1-0-eth/bridge
0 1-1-40-0-efmbond/bridge
Type
State
efmbond
ACT
St
Table Data
UP
UP
Advertisement
Table of Contents
