Zhone etherxtend 3300 series User Manual page 72

EtherXtend SHDSL WAN Interfaces
70
EtherXtend User's Guide
8 entries found.
To display the PME parameters in their default state, enter get pme-profile:
zSH> get pme-profile 1-1-1-0/shdsl
pme-profile 1-1-1-0/shdsl
efmCuPmeAdminSubType: ----------->
efmCuPmeAdminProfile: ----------->
efmCuPAFRemoteDiscoveryCode: ---->
efmCuPmeThreshLineAtn: ---------->
efmCuPmeThreshSnrMgn: ----------->
efmCuPmeLineAtnCrossingEnable: -->
efmCuPmeSnrMgnCrossingEnable: --->
efmCuPmeDeviceFaultEnable: ------>
efmCuPmeConfigInitFailEnable: --->
efmCuPmeProtocolInitFailEnable: ->
efmCuPme2BProfileDescr: --------->
efmCuPme2BRegion: --------------->
efmCuPme2BDataRate: ------------->
efmCuPme2BPower: ---------------->
efmCuPme2BConstellation: -------->
efmCuPme2BProfileRowStatus: ----->
efmCuPmeNtr: -------------------->
For the efmCuPme2BRegion parameter, the regions are set as specified in the
relevant Regional Annex of [G.9991.2]. Regional settings place limitation on
the max allowed data rate, power, and constellation. The possible values for
this parameter are:
•
region 1
Annex A and F (North America)
•
region 2
Annex B and G (Europe)
Regions can only be changed when the link is down.
For the efmCuPme2BDataRate, setting the parameter to 0 sets the data rate to
auto-negotiate. Entering a range between 192 and 5696 defines a specific
range of the data rate.
Table 16 provides the settings for the efmCuPme2BConstellation parameter.
efmCuPme2BConstellaltion settings
Table 16:
Constellation settings
TCPAM16
TCPAM32
Adaptive
{ieee2basetlr}
{0}
{}
{0}
{0}
{false}
{false}
{false}
{false}
{false}
{}
{region1}
{0}
{0}
{adaptive}
{active}
{ntr-local-osc}
Rate range
192 to 3840
768 to 5696
192 to 5696