Ip On A Bridge - Zhone etherxtend 3300 series User Manual

IP on a bridge

zSH> interface add 1-1-6-0/ipobridge vlan 200 10.11.12.13/24
Created ip-interface-record ipobridge-200/ip.
zSH> interface show
2 interfaces
Interface Status
--------------------------------------------------------------------------------
1/1/6/0/ip UP
1/1/99/0/ip UP
--------------------------------------------------------------------------------
zSH> bridge show
Type VLAN
---------------------------------------------------------------------------------
tls 7 1-1-99-0-efmbond/bridge
tls Tagged
tls 7 1-1-1-0-eth/bridge
tls Tagged
tls 7 1-1-4-0-eth/bridge
tls Tagged
tls 7 1-1-3-0-eth/bridge
tls Tagged
tls 7 1-1-2-0-eth/bridge
tls Tagged
tls Tagged 200
IP on a bridge allows you to put an IP address on a bridged VLAN. This
allows VLANs to be used to manage multiple EtherXtends or other devices.
One IP on a bridge can be created on a EtherXtend. The following example
provides a typical example of how you would configure IP on a bridge.
Creating the IP on a bridge interface
Create an IP on a bridge interface using the IP address of 10.11.12.13/24, and
a logical port interface 6 with a VLAN 200
Note: The logical port interface for IP on a bridge must be 1-1-6-0/
ipobridge for correct transmission of IP packets.
1 Enter interface add interface/type with the type as ipobridge:
This command creates the new IP interface as well as a new bridge. The
bridge created will be a Transparent LAN Service (TLS) bridge.
2
Enter interface show to verify the IP interface:
Rd/Address
1 10.11.12.13/24
1 0.0.0.0/0
Enter bridge show to verify the ipobridge:
Bridge
1-1-99-0-efmbond-0/bridge
1-1-1-0-eth-0/bridge
1-1-4-0-eth-0/bridge
1-1-3-0-eth-0/bridge
1-1-2-0-eth-0/bridge
ipobridge-200/bridge
3 Create another bridge on an uplink port to manage traffic going to the
uplink connection with bridge add:
Configure an interface on an Ethernet port
Media/Dest Address
00:01:47:f6:48:25
00:01:47:f6:48:27
St Table Data
UP
UP
DWN
DWN
DWN
DWN
DWN
DWN
DWN
DWN
UP
EtherXtend User's Guide
IfName
ipobridge-200
AutoConfig
65