Zhone etherxtend 3300 series User Manual page 130

Advanced Configuration
ErroredFrame Window
ErroredFrame Threshold
ErroredFrame Notify
ErroredFramePeriod Window
ErroredFramePeriod Threshold
ErroredFramePeriod Notify
ErroredFrameSecondsSummary Window
ErroredFrameSecondsSummary Threshold
ErroredFrameSecondsSummary Notify
DyingGaspEnable
CriticalEventEnable
zSH> eth-oam add 1-4-50-0/efmbond active
zSH> eth-oam add 1-1-40-0/efmbond passive
eth-oam add
128
EtherXtend User's Guide
Configuring OAM support
The OAM interface is defined by an ether-oam profile that specifies the
options for active/passive mode, loopback, and notification for events. By
default, OAM is disabled on all MALC uplink and Ethernet interfaces.
To configure OAM features:
1
Create a new OAM profile for the desired Ethernet interface. By default,
this profile is in passive mode with loopback disabled.
This example configures Ethernet OAM in active mode on EFM bond
group 1-4-50-0/efmbond on a EFM-SHDSL-24 card in slot 4.
2 Create a new OAM profile for the desired EtherXtend interface. By
default, this profile is in passive mode with loopback disabled.
This example configures Ethernet OAM in passive mode on EFM bond
group 1-1-40-0/efmbond on the peer EtherXtend.
3
Enter commands to modify and display OAM parameters.
The eth-oam modify command provides access to configurable settings
in the ether-oam profile.
The eth-oam show command displays configured OAM settings.
The eth-oam stats command displays OAM statistics for a specified
physical interface or bond group or all OAM interfaces.
Configures and enables OAM interface on a physical interface.
Syntax eth-oam interface/type [active | passive]
interface/type
Options
Name and type of the physical interface or bond group.
10
1
enabled
4294967295
1
disabled
100
1
disabled
disabled
disabled