Zhone etherxtend 3300 series User Manual page 90

Configuring Bridging
zSH> get bridge-interface-record 1-1-1-0-eth/bridge
bridge-interface-record
vpi: --------------------------------->
vci: --------------------------------->
vlanId: ------------------------------>
stripAndInsert: ---------------------->
customARP: --------------------------->
filterBroadcast: --------------------->
learnIp: ----------------------------->
learnUnicast: ------------------------>
maxUnicast: -------------------------->
learnMulticast: ---------------------->
forwardToUnicast: -------------------->
forwardToMulticast: ------------------>
forwardToDefault: -------------------->
bridgeIfCustomDHCP: ------------------>
bridgeIfIngressPacketRuleGroupIndex: ->
vlanIdCOS: --------------------------->
outgoingCOSOption: ------------------->
outgoingCOSValue: -------------------->
s-tagTPID: --------------------------->
s-tagId: ----------------------------->
s-tagStripAndInsert: ----------------->
s-tagOutgoingCOSOption: -------------->
s-tagIdCOS: -------------------------->
s-tagOutgoingCOSValue: --------------->
mcastControlList: -------------------->
maxVideoStreams: --------------------->
isPPPoA: ----------------------------->
floodUnknown: ------------------------>
floodMulticast: ---------------------->
bridgeIfEgressPacketRuleGroupIndex: -->
bridgeIfTableBasedFilter: ------------>
bridgeIfDhcpLearn: ------------------->
88
EtherXtend User's Guide
This command adds a downlink to an Ethernet port on the LAN that uses
VLAN 60.
2
To verify the bridge interface, enter bridge-interface-record interface/
type:
Note: It is recommended not to change the default settings
unless advanced bridge configuration is required.
1-1-1-0-eth/bridge
3
To create a bridge interface on the WAN bond group for the upstream
connection, enter bridge add 1-1-bondgroup-0/type uplink vlan vlan id:
zSH> bridge add 1-1-201-0/efmbond uplink vlan 1
This creates a bridge interface on the WAN bond group interface.
4
To create a bridge path for this uplink, enter bridge-path add
1-1-bondgroup-0-interface/type global:
zSH> bridge-path add 1-1-201-0-efmbond/bridge global
{0}
{0}
{60}
{true}
{false}
{false}
{false}
{true}
{100}
{false}
{true}
{false}
{false}
{false}
{0}
{0}
{disable}
{0}
{0x8100}
{0}
{true}
{s-tagdisable}
{0}
{0}
{}
{0}
{false}
{true}
{true}
{0}
{NONE(0)}
{NONE(0)}