Table of Contents
Advertisement
E
X
THER
TEND
WAN SHDSL interfaces
Setting pme-profile settings
SHDSL WAN I
This chapter describes the WAN SHDSL interfaces on the EtherXtend.
•
WAN SHDSL interfaces, page 69
•
EtherXtend EFM 802.3ah bonding, page 76
•
Bond group/physical line stats, page 78
The EtherXtend device can have either 4 or 8 SHDSL WAN interfaces for use
as individual interfaces or as members of a bond group. The EtherXtend
supports 2-wire SHDSL cards.
The EtherXtend uses the shelf-slot-port-subport/type syntax to identify
system interfaces. The EtherXtend is always 1 for the shelf, 1 for the slot
values and 0 for the subport value. The type is based on the Internet Assigned
Numbers Authority interface type (IANAiftype) definitions.
This section describes how to set the following profiles for SHDSL interface
configuration:
•
Setting pme-profile settings on page 69
•
Setting DSL profile settings on page 71
•
Configuring efm-port settings on page 74
A pme-profile (Physical Medium Entities) is available for each SHDSL WAN
port. PME profiles are used to set link rates. To display PME profiles, enter
list pme-profile:
zSH> list pme-profile
pme-profile
1-1-1-0/shdsl
pme-profile
1-1-2-0/shdsl
pme-profile
1-1-3-0/shdsl
pme-profile
1-1-4-0/shdsl
pme-profile
1-1-5-0/shdsl
pme-profile
1-1-6-0/shdsl
pme-profile
1-1-7-0/shdsl
pme-profile
1-1-8-0/shdsl
NTERFACES
EtherXtend User's Guide
69
Advertisement
Table of Contents
