EtherXtend SHDSL WAN Interfaces
EtherXtend EFM 802.3ah bonding
Creating bond groups
76
EtherXtend User's Guide
efmCuTargetWorstCaseMode is TRUE and efmCuTargetWorstCaseSnrMgn
is 0.
Note: Previous releases of EtherXtend show the
efmCuTargetWorstCaseSnrMgn to be 1. Enter the set2dafault
command to view the current default setting of 0.
To view current parameter settings, enter get efm-port interface/type:
zSH> get efm-port 1-1-1-0/shdsl
efm-port
1-1-1-0/shdsl
efmCuPAFAdminState: ---------------->
efmCuPAFDiscoveryCode: ------------->
efmCuAdminProfile: ----------------->
efmCuTargetDataRate: --------------->
efmCuTargetWorstCaseSnrMgn: -------->
efmCuThreshLowBandwidth: ----------->
efmCuLowBandwidthEnable: ----------->
efmCuTargetCurrentConditionMode: --->
efmCuTargetCurrentConditionSnrMgn: ->
efmCuTargetWorstCaseMode: ---------->
EFM (Ethernet in the First Mile) extends Ethernet signaling between the
EtherXtend-EFM-SHDSL-24 card and EtherXtend or other EFM-enabled
CPEs.
By default, all ports are configured in N2N bond groups and can be
re-configured for EFM bonding.
This section describes the following:
•
Creating bond groups on page 76
•
Displaying bond groups on page 77
•
Changing bond group type on page 78
•
Deleting bond groups on page 78
The bond add and list if-translate commands are used to add and verify a
single N2N or EFM bond group. If the bond group already exists, adding an
identical group with a different bond type changes the bond group type.
Note: Bond groups created with CLI commands must be greater
than 24 and less than 100. 100-series bond group IDs are used by
ZMS and 200-series bond groups are auto-provisioned/discovered.
zSH> bond add group 1-1-40-0/n2nbond
{enabled}
{}
{0x01}
{50000}
{0}
{0}
{false}
{false}
{6}
{true}