Zhone etherxtend 3300 series User Manual page 113

IP
downlink CO/CPE 1 VLAN 100
EtherXtend CO
zSH> bond show all
Bond Groups
Slot GrpId
1 99
zSH> bridge add 1-1-40-0/efmbond uplink
Adding bridge on 1-1-40-0/efmbond
Created bridge-interface-record 1-1-40-0-efmbond-0/bridge
Figure 18: EtherXtend CO scenario
EtherXtend CPE 1
downlink CO/CPE 2 VLAN 200
EtherXtend CPE 2
Configure the EtherXtend in CO mode
On EtherXtend in CO mode, create an uplink bridge on a WAN Ethernet port
to connect to the external network and create two downlink bridges on the
WAN ports that connect to the two subtended EtherXtends in CPE mode. In
this example, the downlinks use VLAN 100 and VLAN 200. Then create TLS
bridges from the WANs to the LANs.
Note: This procedure assumes that a device in the network is
connected to the EtherXtend in CO mode.
1
Display the default bond group, enter bond show all:
Name Type
1-1-99-0 efmbond
2
To configure an uplink bridge on the WAN interface enter, bridge add
interface/type uplink using the interface of the bond group.
To create a bridge path for the uplink enter, :
EtherXtend CO and CPE mode bridge scenarios
WAN/LAN TLS bridge
interface using VLAN 100
WAN/LAN TLS bridge
interface using VLAN 200
State
ACT
EtherXtend User's Guide
111