Table of Contents
Advertisement
Basic Configuration
EtherXtend local management interface
EtherXtend remote management interfaces
46
EtherXtend User's Guide
Table 13: EtherXtend default system settings (Continued)
Parameter
Ethernet Interface
Bonding Mode
Login
Password
DHCP Client (WAN)
The EtherXtend unit provides an out-of-band RS232 D serial (craft) interface
to manage the unit locally. To access the serial port, configure the terminal
interface software with the following settings:
•
9600bps
•
8 data bits
•
No parity
•
1 stop bit
•
No flow control
You must perform the initial configuration of the system using the serial
(craft) interface. After completing the initial configuration, you can manage
the EtherXtend device remotely through Telent over the network through the
Ethernet management interface or over the management PVC.
Note: The EtherXtend supports a maximum of two concurrent telnet
sessions and one serial session.
This section describes how the EtherXtend can be managed remotely from the
MALC using the default management interface and how to change the
management interface to manage the EtherXtend from a different IP address:
EtherXtend uses the shelf-slot-port-subport/type syntax to identify system
interfaces. For the EtherXtend, the convention is always 1 for the shelf and 1
for the slot value. The subport is always 0. The type is based on the Internet
Assigned Numbers Authority interface type (IANAiftype) definitions.
By default, Autoconfig assigns a bond group number to the N2N bond group
which may vary depending on which port receives the link first. The
Default setting
Autosensing Enabled
Autonegotiating Enabled
N2N
admin
zhone
Enabled
Advertisement
Table of Contents
