Table of Contents
Advertisement
zSH> interface show
1 interface
Interface
Status
---------------------------------------------------------------------------
1/1/4/0/ip
UP
---------------------------------------------------------------------------
zSH> route show
Dest
------------------------------------------------------------
0.0.0.0/0
192.168.8.1/24
EtherXtend auto-provisioning
Rd/Address
1 172.24.200.133/24
Creating a default route
The following example creates a default route using the gateway
192.168.8.1 with a cost of 1 (one):
route add default 192.168.8.1 1
Verifying the route
To verify that the routes were added, tenter route show:
Nexthop
192.168.8.1
1/1/1/0/ip
To verify connectivity to the default gateway, enter ping:
zSH> ping 192.168.8.1
PING 192.168.10.1: 64 data bytes
!!!!!
----192.168.8.1 PING Statistics----
5 packets transmitted, 5 packets received
round-trip (ms)
To stop the ping, press CTRL+C.
The auto-provisioning feature of the EtherXtend provides a factory default
configuration of EtherXtend interfaces. Auto-provisioning runs during the
initial boot of the EtherXtend or after entering a set2default command.
Note: In order not to run auto-provisioning and to use your own
customized configuration settings, you must either have a default file
or a restore file located in the onreboot directory. To create a default
file see
Customize the EtherXtend default settings, page
a restore file see
During the initial EtherXtend boot, auto-provisioning automatically:
•
Creates an efmbond group, 1-1-99-0/efmbond with all SHDSL interfaces
as members.
Media/Dest Address
00:01:47:07:ef:ee
Cost
Owner
1
STATICLOW
1
LOCAL
min/avg/max = 0/0/0
EtherXtend auto-provisioning
IfName
AutoConfig
53. To create
EtherXtend User's Guide
49
Advertisement
Table of Contents
