Table of Contents
Advertisement
zSH> bond show all
Slot
GrpId
1
40
zSH> bridge add 1-1-40-0-efmbond-0/bridge tls
zSH> bridge add 1-1-1-0-eth/bridge tls
fm1> bridge show
Typ VLAN
---------------------------------------------------------------------------------
tls
0 1-1-1-0-eth/bridge
tls
0 1-1-40-0-efmbond/bridge
EtherXtend bridge commands
Bridge delete command
Bridge show command
Creating TLS bridges on the EtherXtend CPE 2
When using TLS bridges on a device, both the WAN port and the LAN port
must use TLS bridges.
1
To find the bond group number on the WAN, enter the bond show all:
Bond Groups
Name
1-1-40-0
2
To create a TLS bridge interface on the WAN port using the bond group
number, enter bridge add interface/type tls:
3
To create a TLS bridge interface on the LAN port to the business, enter
bridge add interface/type tls:
4
To verify the bridges created, enter bridge show:
Bridge
The EtherXtend supports the following bridge commands:
•
Bridge delete command on page 113
•
Bridge show command on page 113
•
Bridge stats on page 114
Refer to the Zhone CLI Reference Guide for a detailed explanation of the
available bridge commands.
The bridge delete command deletes a specific bridge entry from the system.
zSH> bridge delete 1-1-40-0-efmbond-0/bridge
1-1-40-0-efmbond-0/bridge Delete complete
The bridge show command displays either a single bridge path entry or the
entire bridge table.
Type
State
efmbond
ACT
St
Table Data
UP
UP
EtherXtend bridge commands
EtherXtend User's Guide
113
Advertisement
Table of Contents
