Table of Contents
Advertisement
Advanced Configuration
Modify an EFM port
Create a new EFM bond
802.3ah EFM OAM
124
EtherXtend User's Guide
efmCuTargetCurrentConditionMode: --->
efmCuTargetCurrentConditionSnrMgn: ->
efmCuTargetWorstCaseMode: ---------->
To modify an EFM port, enter update efm-port interface/type to display the
profile parameters.
zSH> update efm-port 1-1-1-0/shdsl
efm-port
1-1-1-0/shdsl
Please provide the following: [q]uit.
efmCuPAFAdminState: ---------------->
efmCuPAFDiscoveryCode: ------------->
efmCuAdminProfile: ----------------->
efmCuTargetDataRate: --------------->
efmCuTargetWorstCaseSnrMgn: -------->
efmCuThreshLowBandwidth: ----------->
efmCuLowBandwidthEnable: ----------->
efmCuTargetCurrentConditionMode: --->
efmCuTargetCurrentConditionSnrMgn: ->
efmCuTargetWorstCaseMode: ---------->
To create a new EFM bond group, enter new efm-bond to display the profile
parameters.
zSH>new efm-bond 1-1-1-0/shdsl
Please provide the following: [q]uit.
config: ------->
dynamic-link: ->
EFM OAM uses an in-band link layer OAM packet exchange between MALC
EFM interfaces and OAM capable CPEs such as the EtherXtend. In this case
the EtherXtend functions as a remote peer to provide discovery, OAM pdu
statistics, and peer information.
When OAM is configured on a MALC EFM interface in active mode, the
discovery process initiates a search for a peer OAM-enabled EtherXtend
configured in passive mode and physically connected to the MALC EFM port
of that interface. If the discovery process does not find an EtherXtend peer,
the discovery process begins again after a five second pause and continues
until a peer OAM-enabled EtherXtend is found.
{auto}:
{enabled}:dynamic
{false}
{6}
{true}
{enabled}:
{}:
{0x01}:
{50000}:
{1}:
{0}:
{false}:
{false}:
{6}:
{true}:
Advertisement
Table of Contents
