Zhone etherxtend 3300 series User Manual page 44

EtherXtend Installation
zSH> get ether 1-1-1-0/eth
ether 1-1-1-0/eth
autonegstatus: ---->
mauType: ---------->
restart: ---------->
ifType: ----------->
autonegcap: ------->
remotefault: ------>
clksrc: ----------->
pauseFlowControl: ->
42
EtherXtend User's Guide
For the best connection results, the remote device should be set to
autonegotiate speed and duplex mode as well. If the remote device cannot be
configured to autonegotiate, speed may be hard set at either 10 Mbps or 100
Mbps. But duplex mode must be hard set to half duplex. A 10/100 Ethernet
connection will not operate properly if the remote device is hard set to full
duplex.
Hard setting the speed and mode of an Ethernet port
In order to manually provision the speed and duplex of the Ethernet port, the
autonegstatus must be set to disabled and any of the following values entered
in the mauType field:
Table 12: mauType field values
mauType
mauType = mau10basethd
mauType = mau10basetfd
mauType = mau100basetxhd
mauType = mau100basetxfd
To change the speed and mode of the Ethernet port, enter the following
commands:
1
To view the Ethernet port interfaces, enter list ether:
zSH> list ether
ether 1-1-1-0/eth
ether 1-1-2-0/eth
ether 1-1-3-0/eth
ether 1-1-4-0/eth
4 entries found.
2
To view the Ethernet port interface parameter defaults, enter get ether
interface/type:
{enabled}
{mau100basetxfd}
{norestart}
{mau100basetxfd}
{b10baseT+b10baseTFD+b100baseTX+b100baseTXFD}
{noerror}
{automatic}
{disabled}
3
To view the ether port interface parameter variables, enter show ether:
Setting
10 Mbps half-duplex
10 Mbps full-duplex
100 Mbps half-duplex
100 Mbps full-duplex