Wiring Details - Honeywell IAQPoint2 User Manual

Introduction

Wiring Details

Wiring Details
The diagram below provides the details required to connect the 301C
with the wireless communication module (coordinator). This module
allows the controller to communicate with and manage the 301W
wireless gas detectors.
Details concerning power supply, cables, capacities, etc., are provided
in the Specifications section at the back of this manual.
SD Card
End-of-line jumper
position
End-of-line specification:
The E.O.L. jumper for
channels 1-2-3-4 must
always be in E.O.L.
position.
V+
PREVIOUS
V-
Always respect minimum
voltage requirements at device
RISK OF ELECTRIC SHOCK
14
Wireless
communication module
LCD screen
B 2
Channel 2
A 2
B 1
Channel 1
A 1
V-
NEXT
Grounding screw
V+
COMMUNICATION
Communication Wire Gauge: Wireless Communication:
2-24 AWG (Belden 9841)
ISM worldwide
Twisted and shielded cable Indoor range 30m
2000 feet (600 m) per channel
T-tap: 65 feet (20 m) / T-tap
130 feet (40 m) total
Channel Specifications:
Channel 1-2: Modbus,Vulbus protocol
Channel 3: Modbus protocol only
Communicates only with Vulcain
transmitters
Channel 4: Modbus output
Communicates only with VA301BDCM
301C User Manual
Honeywell
B 4
Channel 4 (not used)
A 4
B 3
Channel 3
A 3
BacNet/IP MODULE (-BIP option)
Ethernet: 10/100-compatible with 10Base-T
interface, RJ-45
Visual Indicators:
Green LED LINK
Yellow LED ACT
RELAY OUTPUTS
6 4 2
3+5
Normally
4+6
open
1+3
Normally
2+4
5
3 1 closed
RISK OF ELECTRIC SHOCK
M-510324
7/10