Honeywell IAQPoint2 User Manual page 940

Introduction
Wiring Details
Wiring Details
The diagram below provides the details required to connect the 96d to
a gas detection network.
Details concerning power supply, cables, capacities, etc., are provided
in the Specifications section at the back of this manual.
SD Card
End-of-line jumper
position
End-of-line specification:
The E.O.L. jumper for
channels 1-2-3-4 must
always be in E.O.L.
position.
V+
PREVIOUS
V-
Always respect minimum
voltage requirements at device
RISK OF ELECTRIC SHOCK
12
Wireless
communication module
LCD screen
B 2
Channel 2
A 2
B 1
Channel 1
A 1
V-
NEXT
Grounding screw
V+
COMMUNICATION
Communication Wire Gauge:
Wireless Communication:
2-24 AWG (Belden 9841) ISM worldwide
Twisted and shielded cable
Indoor range 30m
2000 feet (600 m) per channel
T-tap: 65 feet (20 m) / T-tap
130 feet (40 m) total
Channel Specifications:
Channel 1-2: Modbus,Vulbus protocol
Channel 3: Modbus protocol only
Communicates only with Vulcain
transmitters
Channel 4: Modbus output
Communicates only with VA301BDCM
96d User Manual
Honeywell
B 4
Channel 4 (not used)
A 4
B 3
Channel 3
A 3
BacNet/IP MODULE (-BIP option)
Ethernet: 10/100-compatible with 10Base-T
interface, RJ-45
Visual Indicators:
Green LED LINK
Yellow LED ACT
RELAY OUTPUTS
6 4 2
3+5
Normally
4+6
open
1+3
Normally
2+4
5 3 1
closed
RISK OF ELECTRIC SHOCK
M-511401
8/10