Honeywell IAQPoint2 User Manual page 37

IAQPoint2™
Main menu
Main Menu
Review
Configure
Calibrate
Simulate
Language/Langue
Access to the main menu is gained after an accepted password (either level 1 or
level 2) has been entered� The Calibrate option is available only with level 2 access�
Review menu
Review
Factory Config.
User Config.
Status
BACnet Config
All of the operational parameters of the monitor can be viewed through the Review
menu�
Review\Factory Config.
This screen shows the factory settings of the IAQPoint2 monitor (serial numbers,
software version number, and time stamp)� Below the time stamp is an indication of
the IAQPoint2 hardware output type� This can be either "Analog" or "RS-485" for the
BACnet/Modbus version� The bottom line shows whether the optional temperature
and relative humidity sensor is fitted� This can have the value "Y" or "N"�
Review\User Config.
This screen summarizes how the IAQPoint2 has been configured� The top two lines
convey the communications settings for the digital fieldbus (protocol name, baud
rate, addresses, and parity)� On analog versions of the product, this line will simply
contain "Analog" because there is nothing to configure� The third line contains the
configuration of the gas sensor including the setpoint and hysteresis�
The fourth line conveys the configuration of the optional temperature sensor� The
numbers include the setpoint and the minimum and maximum settings� The min/
max settings can be adjusted in Configure\Set Max Temp Setpoint and Configure\
Set Min Temp Setpoint below� The fourth row contains calibration information� The
fifth line contains the settings of the optional relative humidity sensor� On IAQPoint2
31