Changing Pan Id Or Rf Channel - Honeywell IAQPoint2 User Manual

Changing PAN ID or RF Channel

When the PAN ID or the RF channel is changed, using the Parameters
menu option within the Wireless Network menu, the system needs
confirmation at more than one option, as described below:
To change the PAN ID:
• Select Parameters from the Wireless Network menu
• Scroll down (using the arrows) to hightlight option 3, PAN ID
• Press Enter to select
• Change the PAN ID values, as desired and press Enter
• The next screen requests either confirmation or cancellation. Press
Enter to confirm (If Esc is pressed, no changes will be made and
the screen returns to the main Wireless Network menu)
• The system displays the RF channel screen; press Enter to
proceed (or to record changed values)
• The next screen requests confirmation or cancellation. Press Enter
to confirm. If Esc is pressed at this point, the changes to the
PAN ID will not be made.
Parameters
1. 7B7177EFACE0049
2. WC Version
3. PAN ID
PAN ID
VAL : FF07
MAX : FFFF
MIN : 0001
Note: Whenever changes are made to the PAN ID or the RF channel,
the network must rebuild itself. Losing the network (entire network
in Fault mode) during this process is normal and should only last
approximately 10 minutes.
M-510324
7/10
PAN ID
Enter to confirm
Esc to cancel
301C User Manual
Honeywell
System Programming
Wireless Network Menu
RF channel
VAL : 011
MAX : 255
MIN : 001
RF Channel
Enter to confirm
Esc to cancel
79