Sun Microsystems Sun Fire T200 Installation Manual page 72

2. Open a Telnet session and connect to the system controller, as in the following
example.
% telnet 129.
Trying 129.xxx.xx.xx...
Connected to 129.xxx.xx.xx.
Escape character is'^]'.
Use is subject to license terms.
Symptom) Advanced Lights Out Manager 1.0.11 ()
Please login:
Substitute the IP address of your system controller.
3. Login as admin, using the password you defined during the configuration of the
system controller.
Please login: admin
Please Enter password: password
sc>
4. Execute flashupdate command.
The flashupdate SC command is used to update the system controller flash image.
The flashupdate command requires the following information:
IP address of a system on the network that can access the flash image
■
The full pathname to the flash image that the IP address specified above can
■
access.
The username and password of an account registered on the system specified by
■
the IP address used above.
The command usage is as follows:
flashupdate [-s IP_address -f pathname] [-v]
-s IP_address is the IP address of any system on the network that can access the
■
flash image
-f pathname is the full pathname to the flash image
■
52 Sun Fire T2000 Server Installation Guide • April 2006
xxx xx xx
. .