Enabling The System Controller Network Management Port; Logging Into The System Controller; To Log Into The System Controller Using The Serial Management Port - Sun Microsystems Sun Fire T200 Installation Manual

Enabling the System Controller Network
Management Port
The system controller network management port is not operational until you
configure network settings for the system controller. Configure the system controller
in this order:
1. After the system controller boots, access the ALOM-CMT command line interface
through the serial management port. See
Using the Serial Management Port" on page
2. Configure the system controller. See
Network Management Port" on page
3. Enable the new values by resetting the system controller. See
System Controller" on page
You can now use the SP network management port at any time to access the system
controller. See
Port" on page

Logging Into the System Controller

If you are powering on the system for the first time after installation, use the system
controller serial port to power on the system and run POST. See
System Controller Using the Serial Management Port" on page
If the network management port has already been configured, you can use it instead
of the serial management port. See
Network Management Port" on page
To Log Into the System Controller Using the
▼
Serial Management Port
After the system controller boots you can access the ALOM-CMT command line
interface to configure and manage the system.
38 Sun Fire T2000 Server Installation Guide • April 2006
42.
"To Log Into the System Controller Using the Network Management
43.
"To Log Into the System Controller Using the
"To Log Into the System Controller
38.
"To Configure the System Controller
39.
43.
"To Reset the
"To Log Into the
38.