To Configure The System Controller Network Management Port - Sun Microsystems Sun Fire T200 Installation Manual

The sc prompt is displayed at the first time the system controller is booted. The
default configuration provides an ALOM-CMT user account called admin. There is
no default password, so you must create a password using the system controller (sc)
password command.
1. If this is the first time the system has been powered on, use the password
command to set the admin password.
.........................
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
sc> password
password: Changing password for admin
Setting password for admin.
New password: new_password
Re-enter new password: new-password
sc>
After the admin password has been set, on subsequent reboots, the sc login prompt
is displayed.
2. Enter admin for the login name followed by your password.
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
Please login: admin
Please Enter password: password
(Press Return twice)
sc>
To Configure the System Controller Network
▼
Management Port
To access the system controller using the network for the first time, you must first
configure the SC network management port through the SC serial management port.
Set these network parameters according to the specific details of your network
configuration:
Chapter 3 Powering On the System 39