Sun Microsystems Sun Fire T200 Installation Manual page 24

4. Mount the server into a rack or cabinet. See
page
Note – In the rest of this manual, the term rack means either an open rack or a
closed cabinet.
5. Connect the server to a serial terminal or a terminal emulator (PC or workstation)
to display system messages. See
page
Tip – The serial terminal or a terminal emulator should be connected before you
connect the power cables, or you will not see the system messages.
6. Connect the data cables to the server, but do not connect the AC power cable yet.
See
7. Connect the AC power cable to the server and examine the display for any error
messages. See
Caution – There is a potential for electric shock if the server and related equipment
are not properly grounded.
Note – The system controller (SC) runs on the 3.3v standby voltage. As soon as AC
power is connected to the system, the system controller immediately powers on,
runs diagnostics, and initializes the ALOM-CMT firmware.
8. After the system controller boots, access the ALOM-CMT command line interface
through the serial management port. See
Using the Serial Management Port" on page
9. Configure the SC network addresses. See
Network Management Port" on page
Note – The SC network management port is not operational until you configure
network settings for the system controller (through the SC serial management port).
10. Enable the new configuration by resetting the system controller. See
the System Controller" on page
11. Power on the server from a keyboard using the ALOM-CMT software. See
Power On the System" on page
4 Sun Fire T2000 Server Installation Guide • April 2006
11.
35.
"Connecting Cables to the Server" on page
"Powering On the System for the First Time" on page
"Installing the Server in a Rack" on
"Powering On the System for the First Time" on
27.
"To Log Into the System Controller
38.
"To Configure the System Controller
39.
42.
44.
35.
"To Reset
"To