How To Back Up The Diagnostic Data Of The Pcs 7 Os - Siemens PCS 7 Service Manual

Hide thumbs Also See for PCS 7:
Table of Contents

Advertisement

Failure - What next?
6.2 Preparing for expert support
● If the STOP LED is lit, read out the diagnostic buffer. For additional information on
● These data can be analyzed by trained service engineers. They contain information about
● If the possibility exists that a hardware error in the I/O caused the CPU to switch to STOP
● Generate a memory dump.
All LEDs are off or are flashing
You recognize the "CPU defective" status by the following LED displays on the front of the
CPU:
● All LEDs are flashing.
● All LEDs are off, even though the power supply is switched on.
For additional support, contact your Siemens representative or Technical Support. Have the
"information in the event of a fault" indicated above ready.
6.2.5

How to back up the diagnostic data of the PCS 7 OS

Basic procedure
We recommend that you back up the diagnostic files for analysis of the cause of the OS fault
by experts.
Back up the diagnostic folder
1. Close WinCC.
2. Back up all diagnostic folders of WinCC
3. Give this information to the service employees.
68
procedures, refer to the "How to read the CPU diagnostic buffer (Page 66)" section
Save the diagnostics buffer to a HEX file and to a TXT file!
the cause, for example:
– I/O error
– Synchronization error with an H-CPU
mode, save the diagnostic buffer of the relevant module and the associated bus interface
module (for example, CP 443-5).
(default: [Installation path]\Siemens\WinCC\Diagnostics).
You can back up the diagnostic files using the shortcut menu command Save to >
Compressed (zipped) Folder.
Note
Once the diagnostic files are backed up (not in diagnostic folder), you can delete the
content of the diagnostic folder. In this way, you avoid keeping old information in the new
diagnostic files.
If the same error occurs the next time you start WinCC, make an additional backup to help
the experts. Only a few messages will need to be analyzed in this backup.
Service support and diagnostics (V8.0)
Service Manual, 03/2012, A5E02779775-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents