Message Lists In Process Mode - Siemens PCS 7 Service Manual

Message type
Operating messages
Process control messages
System messages
5.5.4

Message lists in process mode

Message lists
PCS 7 places incoming messages in message lists. The message is available in different alarm
lists, depending on the event source and on the alarm status.
The following messages lists are available by default. You can modify these standard message
lists or create additional message lists.
Default message lists
List
Incoming alarm list The incoming alarm list contains the alarms which require acknowledgment,
Acknowledged
alarm list
Outgoing alarm list The outgoing alarm list contains the alarms flagged as "Outgoing". Those alarms
History list
Process control list The process control list provides a view of the alarm log, filtered according to
Operation list
The following figure illustrates the path a message takes through the message lists.
Service support and diagnostics (V8.0)
Service Manual, 03/2012, A5E02779775-02
Target group:
Process
management
X
Content
however, which are still pending acknowledgment or deactivation.
The acknowledged alarm list contains the acknowledged process alarms.
are no longer active, but are not yet acknowledged.
The history list provides a view of the alarm log which contains all alarms, except
the operator log.
process alarms (and comparable ones).
Example: Rack failure
Process alarms are also displayed in the following lists:
● Incoming alarm list
● Acknowledged alarm list
● Outgoing alarm list
● History list
The operation list provides a view of the alarm log. The operation list contains the
operator log.
Examples:
● The operator has set the controller setpoint to 5 bar
● The operator has activated the drive
Message concept of PCS 7
5.5 Understanding messages
Target group:
Operations
management and
recording
X
X
Target group: System
specialist and
maintenance specialist
X
X
X
59