Panasonic DP-8032 Service Manual page 269

(36) Execute Parameter Initialize by following the steps below.
a) Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously.
b) Input the password, and select the "OK" button to enter the Service Mode (default password is
00000000).
c) Press the "9" key, and press the "START" key to enter the F9 Service Mode (Unit Maintenance).
d) Select "00 FAX Service Mode".
e) Select "01 Function Param. Setting".
f) Select "005 Destination Code".
g) Select the "CHANGE" button.
h) Input the new Destination Code, and Select the "OK" button twice.
i) Select "06 RAM Initialize".
j) Select "01 Parameter Initialize", and select "Yes" button.
k) After the initialization completion beep, and press the "STOP" key.
l) Press the "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the Service Mode.
m) Reboot the machine after setting the parameter(s) to activate the setting(s). (Turn the Power
Switch on the Left Side of the machine to the OFF then back to the ON position.)
(37) Verify the position of the
bottom of the document, you can adjust its position by following the steps below.
a) Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously.
b) Input the password, and select the "OK" button to enter the Service Mode (default password is
00000000).
c) Press the "6" key, and press the "START" key to enter the F6 Service Mode (Adjust Parameters).
d) Select "69 Stamp Position Adjust".
e) Select the "INPUT" button, and enter a number (-50 to 50).
Note:
A positive number moves the
conversely, a negative number moves it in the opposite direction.
To change the current sign to either +/-, press the "RESET" key.
(Default setting = 0; 0.3 mm/step)
f) Select the "OK" button twice.
g) Press the "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the Service Mode.
Ver. 1.2
stamp on the document. If it is not within the desired location at the
stamp position closer to the trail edge of the document,
269
DP-8032/8025
2008