8.5.2.
Installation
CAUTION!
Turn the Power Switch on the Left Side, and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Caution:
Before installing the Hard Disk Drive Unit, make sure the optional Sorting Image Memory is installed
in the memory socket on the SC PC Board (CN65) first. At least an additional 16 MB (DA-SM16B)
of Sorting Image Memory is required.
Refer to the Installation Instruction of the Sorting Image Memory (DA-SM16B/64B/28B).
Ver. 1.2
(1) Remove 4 Silver Screws.
(2) Open the Rear Cover.
Caution:
If the LEDs on the SC and SPC PC Boards are lit
(ON), the Power to the machine is still ON.
Please read "8.5.2. Installation : CAUTION!" once
again.
(3) Install the DC PC Board onto the Rear Cover as
illustrated.
(4) Secure the DC PC Board with 2 Screws (M3 x 6).
(5) Install 1 Harness Clamp (Small) to the Rear Cover.
(6) Connect the HDD2 Harness (CN143) and DC12
Harness (CN141 & CN142).
(7) Secure the DC12 Harness and HDD2 Harness with
the Harness Clamp (Small).
273
DP-8032/8025
2008