Panasonic DP-8032 Service Manual page 252

Ver.1.2
Caution:
Exercise caution not to scratch the surface of the
OPC Drum (Green), and not to touch it with bare
hands.
(41) Fasten the Process Unit with 1 Screw.
(42) Connect the Harness, and reinstall the Connector
Cover and 1 Screw.
Caution:
When reconnect the Harness, make sure the
connector position and its keys. Insert it gently, and do
not force the connector if it is facing the wrong way.
Caution:
When reinstalling the Connector Cover, make sure
the Harness is not pinched by the Cover.
(43) Shake the Toner Bottle 10 to 15 times to loosen the
contents.
(44) Remove the Tape, however, do not open the Shutter
or Toner will spill.
(45) Insert the Toner Bottle into the Hopper Unit. Align the
Toner Bottle Key with the Key Alignment Channel of
the hopper unit. Insert the Bottle as far as it will go,
and turn the Toner Bottle clockwise until it locks in
place. (Bottle's Green Knob is lined up with the
"Locked" symbol on the Process Unit label)
(46) Install the Toner Waste Container.
(47) Close the Front Cover and the Right Cover.
(48) Load paper into all of the trays.
(49) Plug the AC Power Cord.
(50) If required, connect the LAN / USB Cable
(not included).
(51) Turn the Main Power Switch on the Back, and the
Power Switch on the Left Side of the machine to the
ON position.
Note:
Perform the following adjustments after the machine
has warmed up, and displays:
Ready To Copy
Set Originals
252
DP-8032/8025
2008