Panasonic DP-8032 Service Manual page 182

No. Item
110 Paper Feed Motor
111 Paper Alignment Motor
112 Paper Tray Lift Motor
113 Stapler Motor
114 Paddle Solenoid
115 Large Gear Solenoid
116 Paper Hold Lever
Solenoid
117- Not Used
119
120 Lamp
121- Not Used
159
160 ADF Motor Rotating
(35% speed rotating)
161 ADF Motor Rotating
(100% speed rotating)
162 ADF Motor Rotating
(400% speed rotating)
163 ADF Motor Reverse
Rotating
(35% speed rotating)
164 ADF Motor Reverse
Rotating
(100% speed rotating)
165 ADF Motor Reverse
Rotating
(400% speed rotating)
166 ADF Paper Feed Roller
Clutch 1
167 ADF Paper Feed Roller
Clutch 2
168 ADF Paper Feed Roller
Clutch 3
169 ADF Paper Exit Solenoid When ADF PCB CN26-2 signal level changes to
170- Not Used
171
172 ADF Solenoid
173 ADF Inverting Solenoid
174 ADF Pinch Roller
Solenoid
175 ADF Stamp Solenoid
Ver.1.2
F4 Mode (Output Check)
Function
Feed Motor rotates.
Paper Alignment Motor drives the Alignment
Plate.
Paper Tray Lift Motor drives the Paper Tray up
and down.
Stapler Motor rotates 2 sec. cycle.
Solenoid turns ON/OFF 500 msec. cycle.
Solenoid turns ON/OFF 500 msec. cycle.
Solenoid turns ON/OFF 1 sec. cycle.
When SDR PCB CN656-1 signal level changes to
0V from +5V, Lamp operates.
ADF motor rotates at 35% speed.
ADF motor rotates at 100% speed.
ADF motor rotates at 400% speed.
ADF motor rotates in reverse at 35% speed.
ADF motor rotates in reverse at 100% speed.
ADF motor rotates in reverse at 400% speed.
When ADF PCB CN22-10 signal level changes to
0V from +24V, clutch operates for 3 seconds.
When ADF PCB CN22-8 signal level changes to
0V from +24V, clutch operates for 3 seconds.
When ADF PCB CN24-2 signal level changes to
0V from +24V, clutch operates for 3 seconds.
0V from +24V, Solenoid operates for 3 second.
When ADF PCB CN26-5 signal level changes to
0V from +24V, Solenoid operates for 1 second.
When ADF PCB CN26-3 signal level changes to
0V from +24V, Solenoid operates for 1 second.
When ADF PCB CN26-7 signal level changes to
0V from +24V, Solenoid operates for 1 second.
When ADF PCB CN25-2 signal level changes to
0V from +24V, Solenoid operates for 1 second.
182
DP-8032/8025
Remark
(Ref.No.)
1Bin Finisher (FS300)
No. 110-116 (3014)
(2931)
(2511)
---
(2728)
(2610)
(2613)
(204)
(1801)
(1801)
(1801)
(1801)
(1801)
(1801)
(1788)
(1787)
(969)
(1762)
(1770)
(1770)
(1762)
(1635)
2008