Panasonic DP-8032 Service Manual page 315

8.20.2. Installation
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the machine
to the OFF position, and then unplug the AC Power Cord before beginning installation.
Ver. 1.2
(1) Remove the Glass Assembly.
(Refer to 2.2.3. of the Service Manual)
(2) Remove 7 Screws.
(3) Remove the CCD Cover.
(4) Disconnect the CCD Harness.
Note: (For Euro Destination only)
The EMI Bracket is already installed, remove it first.
(5) Mount the Heater (with Heat Sheet) onto the
Dehumidifier Bracket.
(6) Install the Heater Assembly.
(7) Secure the Heater Assembly with 1 Screw
(XTB3+6J).
(8) Route the Harness of the Heater Assembly to the
lower section of the frame through the access hole as
illustrated.
315
DP-8032/8025
2008