Snmp Configuration Examples; Snmpv1/Snmpv2C Configuration Example - HP 5500 EI Series Configuration Manual

Task
Display SNMP group information.
Display basic information about
the trap queue.
Display the modules that can send
traps and their trap status (enable
or disable).
Display SNMPv3 user information.
Display SNMPv1 or SNMPv2c
community information.
Display MIB view information.

SNMP configuration examples

This section gives examples of how to configure SNMPv1 or SNMPv2c, SNMPv3, and SNMP logging.

SNMPv1/SNMPv2c configuration example

Network requirements
As shown in
(1.1.1.1/24), and the agent automatically sends traps to report events to the NMS.
Figure 25 Network diagram
Configuration procedure
1. Configure the SNMP agent:
# Configure the IP address of the agent, and make sure the agent and the NMS can reach each
other. (Details not shown.)
Figure 25, the NMS (1.1.1.2/24) uses SNMPv1 or SNMPv2c to manage the SNMP agent
Command
display snmp-agent group [ group-name ] [ |
{ begin | exclude | include }
regular-expression ]
display snmp-agent trap queue [ | { begin |
exclude | include } regular-expression ]
display snmp-agent trap-list [ | { begin |
exclude | include } regular-expression ]
display snmp-agent usm-user [ engineid
engineid | username user-name | group
group-name ] * [ | { begin | exclude | include }
regular-expression ]
display snmp-agent community [ read | write ]
[ | { begin | exclude | include }
regular-expression ]
display snmp-agent mib-view [ exclude |
include | viewname view-name ] [ | { begin |
exclude | include } regular-expression ]
71
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
(This command is
supported only in
non-FIPS mode.)
Available in any view.